Calacatta Shower with Built-In Niche in Loomis

Walk-in shower under construction with white Calacatta wall tiles pebble floor and built-in niche in Loomis residential bathroom

About This Project

This Loomis bathroom shower was built from the studs out. The homeowner wanted a walk-in shower with a built-in niche, white Calacatta wall tile, and a pebble mosaic floor — a classic combination that requires careful planning to execute cleanly. The niche was framed between studs, waterproofed independently, and tiled with the same Calacatta material as the walls so the niche reads as part of the wall rather than an interruption of it.

The photo shows the installation mid-process, with leveling clips still in place. The Calacatta porcelain tiles are 12x24, set in a horizontal running bond. The clips ensure that no tile edge sits higher than the adjacent piece — particularly important at this scale, where even 1/16 inch of lippage is visible and catches the eye. The pebble mosaic floor was installed after the wall tile was grouted and cured, so the grout color of the floor could be selected to complement the finished wall.

What We Did

1

Framed built-in niche; installed cement board and waterproofing on all surfaces including niche

2

Set 12x24 Calacatta porcelain walls with leveling clip system; niche tiled to match

3

Grouted walls with light grey unsanded grout; allowed full cure before floor work

4

Installed pebble mosaic floor; sealed pebble pre-grout; grouted and sealed

Call Us